Q: How do I make my image fit onto diecuts on Rippedsheets.com label material?

A: Using your graphics software, make the margins and distances between labels the same as those on the Rippedsheets.com label sheets you receive. Just measure the sheets you get and then step and repeat the design in your software to match. Please follow these instructions:

1. Print your labels on regular bond paper. Place the printed bond paper against a custom Rippedsheets.com label sheet in front of a light to make sure that the label diecuts and your art match and line up. Make repeated adjustments in your software to nudge your art into the correct position. DO NOT WASTE YOUR CUSTOM LABEL SHEETS IN THIS SET-UP PROCESS.
   
   
2. Once your artwork and the Rippedsheets.com label diecuts match up as described above, Print one sheet of the Rippedsheets.com label material through the printer using your artwork. Follow the instructions on your set up sheet for your custom labels from Rippedsheets.com "TO THE T"! This includes using proper label sheet orientation: The "X" mark (marked on the first sheet with a neon flag) goes in the upper-left corner.
   
   
3. If the printing of your art on the Rippedsheets.com label sheet is off, please measure the amount that it is off with your ruler and adjust your artwork accordingly. For instance, if it is printing 1/8" too high move your art down 1/8" on the page, then print one more label sheet.
   
   
4. Repeat step 3 if necessary.