Description:

The print quality of this bright white matte paper label material is excellent. The Ultra-Removable Self Adhesive is easily removed (similar to a 3M Post-It®) and leaves no residue, and can be applied, removed and applied again and again. This material can be used just like static cling but will adhere to more materials including plastics, paints, paper, cartons, etc.

Facestock

Laser EDP is 60# white high strength uncoated ground wood-free paper with good receptivity to toner and inkjet imaging.  

Caliper

4.7 mil

Adhesive

Water based adhesive dispersion developed to provide good temporary adhesion to a variety of substrates.  It exhibits good adhesion and clean long term removability from most smooth surfaces such as hard plastics, metal, glass, and paper.  This adhesive is unique however, in that it also adheres to many challenging surfaces such as Teflon, Textured PVC, and corrugated. Excellent UV resistance.  Complies with FDA 21CFR 175.105

Adhesive Thickness   (mils)                   0.5                TEST METHODS

Adhesion (oz/inch) 

            6

 Modified PSTC-1

Service temperature range

         -20F

 +250F

Min. application temp:                         +20 F                      

Note: For best bonding conditions, application surface should be at room temper-ature or higher. Low temperature surfaces, below +40F can cause the adhesive to become so firm that it will not develop maximum contact with the substrate.  Higher initial bonds can be achieved through increased rubdown pressure.  In order to get a true measure of the adhesive’s effectiveness, the label should be applied and allowed to bond a minimum of 24 hours prior to evaluation.

Liner

Remoisturized calendered coated two sides bleached Kraft with high internal strength and excellent dimensional stability for roll to sheet lay flat.

Caliper:                      3.5 mils

   Weight:                          50#

The above are typical technical values and are given in good faith based upon our most up to date knowledge and experience.  As the products are used outside our control we cannot take responsibility for any damage that may be caused using the product.  In every case, user shall determine before using any product in full-scale production, or in any way, whether such product is suitable for user’s intended use for their particular purpose under their own operating conditions.