Order: 1-888-791-9590

International Shipping Available
Se Habla Español

101407 Waterproof Scuff Resistant Brushed Silver Polyester Permanent Self Adhesive Labels

Product Information


This is a top-coated, metalized, brushed silver polyester film label with the high-tech look of brushed stainless steel. It has a permanent, pressure sensitive, acrylic adhesive and is backed with a two-side poly coated, lay flat, quick-release liner. This material has an overall weight of .3062 lbs. per msi, and an overall thickness of 9.9 mils. It proved to be dimensionally stable after 24 hours at 160°F.


Metallized, brush stainless polyester film, top-coated for laser printing.

  • Caliper: 2.0 mil


Clear acrylic adhesive

  • Adhesive Thickness (mils): 1.0 - 1.1
  • Adhesion (oz/inch): 54 - 71 depending upon substrate
  • Service temperature range: -40°F to 302°F

  • Min. application temp: 50°F

Note: For best bonding conditions, application surface should be at room temper-ature or higher. Low temperature surfaces, below 50°F can cause the adhesive to become so firm that it will not develop maximum contact with the substrate. Higher initial bonds can be achieved through increased rubdown pressure. In order to get a true measure of the adhesive's effectiveness, the label should be applied and allowed to bond a minimum of 24 hours prior to evaluation.


Two sided, poly coated, lay flat, quick release liner

  • Caliper: 6.9 mils

The above are typical technical values and are given in good faith based upon our most up to date knowledge and experience. As the products are used outside our control we cannot take responsibility for any damage that may be caused using the product. In every case, user shall determine before using any product in full-scale production, or in any way, whether such product is suitable for user's intended use for their particular purpose under their own operating conditions.