Description:

This durable vinyl material features a special water-based matte topcoat that offers excellent toner anchorage and printability. An aggressive permanent acrylic adhesive with excellent clarity, high initial tack, high shear and ultimate adhesion make it suitable for application to a wide variety of surfaces.  Applied labels will be resistant to water, mild acids, bases, salts, most petroleum based oils, greases and allphatic solvents. The kraft liner gives a controlled release.

Facestock

Flexible, top-coated white vinyl for excellent dry laser toner anchorage (Not Thermal Transfer Ribbon compatible)

Caliper:

3.4 mils

Opacity

NA

Adhesive

Emulsion Acrylic

Caliper                                 .9 mils

Min. application temp: 

+10F 

 Indirect Food:            Yes

Min. service temp: 

-40F 

 Direct Food:               No

Max. service temp:               +300 F                     UL Approved:             No

Typical Performance Data: 2 Mil Clear Polyester at room temperature on standard lab panels

Stainless Steel
Loop Tack: 2.77 lbs
Peel Adhesion: 4.1 lbs

Aluminum
Loop Tack: N/A
Peel Adhesion: 4.4 lbs

Alkyd Enamel Paint
Loop Tack: N/A
Peel Adhesion: 3.9 lbs

Polypropylene
Loop Tack: N/A
Peel Adhesion: 4.3 lbs

HDPE
Loop Tack: N/A
Peel Adhesion: 4.6 lbs

Note: For best bonding conditions, application surface should be at or above minimum application temperature. Low temperature surfaces, below +10F can cause the adhesive to become so firm that it will not develop maximum contact with the substrate.  Higher initial bonds can be achieved through increased rubdown pressure.  In order to get a true measure of the adhesive’s effectiveness, the label should be applied and allowed to bond a minimum of 24 hours prior to evaluation.

Liner

Bleached kraft paper liner featuring good back printability

Caliper:                       4.9 mils

Weight:                        79#

The above are typical technical values and are given in good faith based upon our most up to date knowledge and experience.  As the products are used outside our control we cannot take responsibility for any damage that may be caused using the product.  In every case, user shall determine before using any product in full-scale production, or in any way, whether such product is suitable for user’s intended use for their particular purpose under their own operating conditions.