Waterproof Satin Gloss Polyester Removable Adhesive Labels
#102200 - Satin Gloss Polyester Removable Label
This label material is a white polyester with a removable adhesive. Depending on your printer manufacturer, print quality is either high gloss or satin four color process that is water, solvent, and scuff resistant for indoor and short-term outdoor applications. The adhesive is a clear removable acrylic adaptable to many surfaces with a minimum application temperature of 41°F and a service range 14°F to 176°F with a 248°F five minute maximum.
This label features a standard pressure sensitive construction including a 2 mil laser-printable matte polyester Facestock that has excellent heat resistance and dimensional stability. This material features a specialty moderately aggressive removable adhesive (1 mil) that shows good initial tack, high shear strength, high removable strength and excellent clarity. The clay-coated kraft liner has been coated one side to give a controlled release.
2 mil white top-coated polyester with a very smooth matte finish. It has excellent tear strength, heat resistance and dimensional stability while the top-coating offers excellent laser toner receptivity.
- Caliper: 2.0 mil
- Opacity: 75%
- Indirect Food: Yes
- Direct Food: Yes
Clear acrylic adhesive featuring good removability on a wide range of substrates including corrugated and many plastic surfaces.
- Coat weight: 1.0 cwt
- Caliper: 1.0 mil
- Min. application temp: 40°F
- Indirect Food: Yes
- Min. Service Temp: 14°F
- Direct Food: No
- Max. service temp: 176°F
Note: For best bonding conditions, application surface should be at room temperature or higher. Low temperature surfaces, below 40°F can cause the adhesive to become so firm that it will not develop maximum contact with the substrate. Higher initial bonds can be achieved through increased rubdown pressure. In order to get a true measure of the adhesive's effectiveness, the label should be applied and allowed to bond a minimum of 24 hours prior to evaluation.
- Clay-coated lay-flat liner which has been silicone coated one side to give a controlled release.
- Caliper:4.0 mils
- Weight: 74#
The above are typical technical values and are given in good faith based upon our most up to date knowledge and experience. As the products are used outside our control we cannot take responsibility for any damage that may be caused using the product. In every case, user shall determine before using any product in full-scale production, or in any way, whether such product is suitable for user's intended use for their particular purpose under their own operating conditions.
This product is currently available by special order. Pricing and shipping quotes available on request. Alternative materials may be available in stock. Please Contact Us for more information.