Order: 1-888-791-9590

International Shipping Available
Se Habla Español

Tamper Proof Checkerboard Labels

#102350-20 - Dull Metallic Permanent Tamper Proof Label

Tamperproof label
Printability
Laser
Finish
Silver
Material
Polyester
Adhesive
Permanent
Durability
Not Waterproof
Certification
WEEE

These tamperproof labels have a dull silver look to them and a checkerboard self adhesive that if removed after application leaves a checkerboard pattern indicating tampering. The adhesive is a clear acrylic adaptable to many surfaces with a minimum application temperature of 50°F, and a service temperature range of -40° F to 302° F.

Short Run

Price includes die cutting sheets up to 30 cuts (see Plus Charges for additional cuts) with any shape or size.
Sheet Ct.Price Per Sheet
8.5″ × 11″8.5″ × 14″8.5″ × 17″
10$7.01$8.92$10.84
25$6.64$8.42$10.25
50$6.25$7.99$9.69
100$5.90$7.52$9.14
250$5.84$7.42$9.02
500$5.74$7.31$8.88

Let us print for you! Full Color Printing available.

Specifications

Description:

This laser material has a dull silver look to it and a checkerboard self adhesive that if removed after application leaves a checkerboard pattern indicating tampering. Must be printed only on a "Low Speed" Desktop Color or Black and White Laser Printer (For HP: Tuff Paper Setting). The adhesive is a clear acrylic adaptable to many surfaces with a minimum application temperature of 32°F, and a service temperature range of -40°F to 302°F. The tamper evident feature of this product becomes permanently nonfunctional after exposure to 104°F (40°C) temperature.

Facestock

  • Metalized silver polyester film
  • Caliper: 2.4 mils

Adhesive:

  • Emulsion acrylic permanent
  • Caliper: 1.0 to 1.1 mils
  • Min. application temp: 50°F
  • Indirect Food: No
  • Min. Service Temp: -40°F
  • Direct Food: No
  • Max. service temp: 362°F

Note: For best bonding conditions, application surface should be at room temperature or higher. Low temperature surfaces, below +50°F can cause the adhesive to become so firm that it will not develop maximum contact with the substrate. Higher initial bonds can be achieved through increased rubdown pressure. In order to get a true measure of the adhesive's effectiveness, the label should be applied and allowed to bond a minimum of 24 hours prior to evaluation.

Liner:

  • Bleached 5.7 mil kraft paper (lay-flat) liner that has been poly coated two sides to give a controlled release.
  • Caliper: 5.7 mils
  • Weight: 82#
  • Kraft Liner Basis weight: 128g

The above are typical technical values and are given in good faith based upon our most up to date knowledge and experience. As the products are used outside our control we cannot take responsibility for any damage that may be caused using the product. In every case, user shall determine before using any product in full-scale production, or in any way, whether such product is suitable for user's intended use for their particular purpose under their own operating conditions.

Availability

This product is stocked and can be shipped in as little as 24 hours. Please contact us for more information.